Date   : Wed, 27 Jul 1983 23:05:07 EDT
From   : Rick Conn <rconn@brl>
Subject: ZCPR2 on MicroDecision

       I just got back from going over the MD installation of ZCPR2
at a friend's house, and I discovered an error in the instructions.
Very sorry about that.

       The Fill instruction after the DDT load should read

               FD00 1500 0

and the two Read instructions should read

               R3100

       Everything else should be fine.  Again, sorry for the mistakes.
Would those users who contacted me about problems with the MD installation
try it again with these changes and let me know (either way) of their
success?  Thanks.

               Rick