Date : Thu, 07 Jul 1988 16:07:30 GMT
From : ea.ecn.purdue.edu!wieland@ee.ecn.purdue.edu (Jeffrey J Wieland)
Subject: Kaypro and Spinwriter 7710
In article <12412216898.11.D-ROGERS@EDWARDS-2060.ARPA> D-ROGERS@EDWARDS-2060.ARPA
writes:
>I received no reply on this before and i still need help. I have a friend
>with a Kaypro 4 and an NEC 7710 Spinwriter. They don't seem to talk to
...
>the Kaypro to dump a character stream? It also has a parallel port, but
>the software didn't have any procedures to reassign any logical devices.
>H E L P !
> [dale]
>-------
There should be a program on your system disk called "CONFIG.COM". This
program permits you to change many of system's parameters, including the
assignment of the LST: device, baud rates, numeric keypad and cursor key
character generation, etc. You may also reassign logical devices with
"STAT.COM" (also on your system disk). It is documented in your CP/M
manual. For example:
A0>stat dev:
will produce a listing of the logical device assignments.
The actual pin assignments on your Kaypro should be in your Owner's Manual.
Interfacing the Kaypro to a serial printer is discussed at some length in
"The RS-232 Solution", available from Sybex Computer Books. Kaypro
apparently did some strange things to the RS-232 interface (but then who
hasn't!).
Jeff Wieland
wieland@ecn.purdue.edu