Date   : Mon, 08 Mar 2004 19:29:26 +0000
From   : Mike Tomlinson <mike@...>
Subject: Re: Filestore E01 dismantling...

In article <1078065352.32566.63.camel@...>, Jules
Richardson <julesrichardsonuk@...> writes
>
>Anyone have any idea how to take a Filestore E01 apart? :-)

Turn it upside down and place on a folded towel.  Start with the rear
plastic bezel facing you.  This is held to the base by two plastic
'fingers'.  You need three hands for this, so go somewhere quiet and
mutate.  With two hands, gently lift the plastic fingers up with your
fingertips and with the third, pull the bezel back and swivel it down.
The bezel is retained by the plastic side pieces and three small clips
in the top surface.  Lift it away and put to one side.

Turn the FileSnore around and repeat for the front bezel, using a bit of
tape to hold the flap in place so it doesn't fall open or get caught on
anything and break.  Be careful of 1) the wires which pass through the
front of the metal chassis to the LEDs in the bezel and 2) the plastic
finger that retains the flap in the closed position.

Undo the 6 screws holding the metal top on, turn the FileSnore back over
so it's the right way up, again being careful of the LED wires, and the
metal top will now slide off.

Mike

-- 
A. Top posters.
Q. What's the most annoying thing on Usenet?