Date   : Wed, 27 Jul 2005 20:53:42 +0200
From   : "Mark Usher" <mu.list@...>
Subject: Re: Econet-Ethernet bridge

>This one has provision for supplying a clock to the network, 
>though it needs to have the actual line driver added.  
>Would anybody like to suggest a suitable device?

The last one I used when I built a clock/hub (diagram at
http://members.aon.at/~musher/babel/hub.gif) a few years ago was the MC1441P
as per the Econet AUG.

Didn't have any problems sourcing it, and has been chugging away on and off
(so to speak) since.

Note: There was a slight adjustment made to the above design by adding 100
ohm resistors between LK1 & LK2 and LK3 & LK4. I seem to remember it being
because of the short distance of my Econet.

Mark