<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>
Date   : Sun, 23 Mar 2008 17:31:10 +0000
From   : robert@... (Rob)
Subject: Econet Terminator (circuit / wiring diagram)

On 23/03/2008, Andy Ford <acorn@...> wrote:
>
>  "A three-resistor divider chain, 1K0 at the top, 220R in the middle, 1K0
>  at the bottom, connected to ground (pin 2).  Data+ (pin 1) goes to the
>  to of the 220R, Data- (pin 4) goes to the lower end.  A pair of 56R
>  resistors goes from each of Clock+ (pin 3) and Clock- (pin 5) to the
>  top of the upper 1K0.  A 10 uF electrolytic goes from the junction of
>  the 2 x 56R and upper 1K0, to ground."
>
>  I just need to grab some veroboard (or something similar) at some point. I
>  have already made a couple of socket boxes and two terminator boxes (minus
>  the internals)


..that sounds like how mine are made - mounted inside a  DIN plug!
Well, it was once ... there's a picture of it with my DIY socket boxes
here:
http://www.irrelevant.com/bbc/socketbox.jpg
<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>