<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>
Date   : Tue, 25 Mar 2008 10:51:01 +0000
From   : chris.priest@... (Chris Priest)
Subject: Help with setting station number on M128,

Hi Andy,

Make sure the co-pro is disabled before attempting to change the station 
ID, I found that trying to set the station ID with the tube enabled 
resulted in it not accepting the ID.

I used Ian's program as well and it definitely works with the tube 
switched off.

This definitely worked for me.

Best Regards
Chris

Andy Ford wrote:
> Just a quick one. :)
>  
> I need to set the Station ID on my Master 128.
>  
> I tried to use Ian's (Beebmaster) program to set the station Id on my 
> Econet Enabled 128. However, it ignores the change.
>  
> I reset the CMOS and tried again without luck. It has set itself to 
> 253. I would like it to be station 254 ideally (File server)
>  
> The only thing I can think of (I do not have a M128 guide to hand) , 
> when I ran through the setup on the Welcome Disk, I set the default FS 
> to 0.254 on that screen (not sure of the proper name for it, the 
> config program included in the Welcome Disk)
>  
> I understand it is on one of the Econet disks too (a "Set" program) if 
> i remember correctly ?
>  
> Can someone point me towards which disk ( I should be able to find it 
> ;) ) , recommend an alternative please or give me a pointer ( I may 
> have just over looked something simple :D )
>  
> Thanks.
>  
> Andy.
>  
>  
>  
> ------------------------------------------------------------------------
>
> _______________________________________________
> bbc-micro mailing list
> bbc-micro@...
> http://lists.cloud9.co.uk/mailman/listinfo/bbc-micro
>   
<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>