Date   : Sat, 25 Oct 2008 12:01:02 +0100
From   : acorn@... (Andy Ford)
Subject: Econet Library (load and exec addresses)

I should know this but I cannot remember nor find the actual information 
(even though I could swear I have seen it in a manual)

Basically, I have set up my L3 econet again after six months (no data 
saved) and transferred the basic Library utilities into it (*users / 
*view / *prot etc)

But as I transferred them via an image to adfs explorer > to xfer > and 
finally via copyfiles to the network, they have no load or exec addresses :(

Does anyone know off hand what they are please ? (Pretty sure its the 
same for all the standard utils in the Library directory)

Also, I plan to use JGH's net utils too, I assume these have the same 
load and exec address's ?

Thanks in advance :)


Andy.