Date   : Tue, 12 May 2009 08:55:48 -0500
From   : jules.richardson99@... (Jules Richardson)
Subject: My Rodime Wont Spin

Julian Stenning wrote:
> 
> 
> Having just read the below again more thoroughly, I realised the smaller
> ribbon cable was in J1, not J0 (I assume from when I had both the rodime &
> WD drive connected at the same time).

Hmm, make sure you have the drive termination resistors set up properly if 
you've been playing around with two drives on the same controller, or all 
sorts of odd things might start happening...  (sorry if I'm stating the 
obvious :-)

cheers

Jules