Date   : Tue, 07 Jul 2009 19:56:47 +0100
From   : mike@... (Michael Howard)
Subject: Econet over UTP ?

Phil Blundell wrote:
> So, current spec approximately as follows...
> 2 DIN sockets on front edge
>
> 2 RJ45 sockets on sides
>
> Either or both RJ45s can be replaced with internal Krone punchdown
> blocks, per request from Rob.  (You can't have the RJ45 and Krone on the
> same side though, since the footprints overlap.)
>
> You can split the box in half, i.e. isolate the two sides from each
> other, by cutting some links on the back of the board.  This gives you a
> similar configuration to the SJ "split socket box".
>
> One or two sets of termination components can be installed on the board.
> Obviously, installing two sets is only useful in the split configuration
> unless you are building a very small network :-)
>
> Any more takers?
>   
Yep, put me down for a couple!

Mike.
--