Date   : Tue, 31 Jul 1984 10:45:00 MDT (Tue)
From   : Keith Petersen <W8SDZ@Simtel20.ARPA>
Subject: GEMSET10 setup program for Gemini-10 printer

GEMSET10 is a version of MXSET by Simon J. Ewins set up for a
Gemini-10 printer.

The following has been done -

        1. Home printhead command removed.
        2. Carriage return and linefeed not sent to printer after commands.
        3. Proportional spacing command added.
        4. 12 cpi command added.
        5. Start column command added.
        6. Lines per inch command added.
        7. Formfeed command added.
        8. Optional printer status checking added.
        9. Header line position command added.
       10. Eliminated stack imbalance and improper use of PRINT##.

Here is a short review of MXSET:

MXSET Rev. 1.2 by Simon J. Ewins, Toronto, Ontario, Canada.

This program will set/reset all of the major functions of the Epson MX-80
printer. The program uses Z80 Zilog mnemonics and calls are made to Richard
Conn's excellent SYSLIB.REL file. Microsoft's M80 macro assembler is needed
for assembly of this file as well as the SYSLIB file.

The GEMSET files are available on SIMTEL20 as:

Filename                       Type     Bytes   Sectors     CRC

Directory MICRO:<CPM.LIST>
GEMSET10.COM.1                 COM       2816   22 =  16H  CE53H
GEMSET10.HEX.1                 ASCII     7933   62 =  3EH  497EH
GEMSET10.MAC.1                 ASCII     7127   56 =  38H  0B96H
GEMSET10.MSG.3                 ASCII      549    5 =   5H  B324H

The original MXSET12 files are also available for Epson owners:

Filename                       Type     Bytes   Sectors     CRC

Directory MICRO:<CPM.EPSON>
MXSET12.COM.1                  COM       2176   17 =  11H  EED5H
MXSET12.HEX.1                  ASCII     6133   48 =  30H  2923H
MXSET12.MAC.1                  ASCII     4068   32 =  20H  DB1DH