Date   : Thu, 26 May 1988 13:25:59 GMT
From   : cadnetix.COM!cadnetix!rusty@uunet.uu.net (Rusty)
Subject: MexPack VT100 Emulator (and Kaypro)

In article <10033@sol.ARPA> ciaraldi@cs.rochester.edu (Mike Ciaraldi) writes:
>
>Will it support the VT100 application keypad?
>...
>I'm looking for a good VT100 emulator for a Kaypro 2.
>It has to have application keypad support.
>...
>Any suggestions?
>
>Mike Ciaraldi
>...rochester!ciaraldi

Well, see if the people at SoftKlone - the makers of Mirror (a crosstalk(R)
clone) - have Mirror for CP/M (R).  I doubt it, but it is worth a check,
as their MS/DOS (R) Mirror (R) has both Vt100 and Vt52 emulation.  I have
not checked to see about keypad support.  Go to your local software
store and ask them to look up SoftKlone or Mirror (R) and give you
the address/phone number.

Or email me and I will find where I hid the documentation for Mirror
("Its here **SOMEWHERE**, I KNOW it! :-("....
---
    Rusty Carruth      N7IKQ   DOMAIN: rusty@cadnetix.com
    Cadnetix Corp.             UUCP:   cadnetix!rusty
    5775 Flatiron Pkwy.                        {uunet,boulder,nbires}!cadnetix!rusty
    Boulder, CO 80301          (303) 444-8075


End of INFO-CPM Digest
******************************