Date   : Mon, 20 Jun 1988 22:44:47 GMT
From   : cadnetix.COM!cadnetix!rusty@uunet.uu.net (Rusty)
Subject: Need info on Osborne-1 power supply?

In article <1061@astroatc.UUCP> niemi@astroatc.UUCP (Bob Niemi) writes:
><question about osborne hardware info>

Also, in another, unrelated article, someone asks for hardware info on
the osborne 1...

Amazingly enough, the Osborne 1 is one of the few computers for which
you can get a Sams (r) Photofact (r) 'thingie'.  Complete schematics!

Go look in your local public library for this little gem.  The Phoenix
public library in Phx Az (not much use to you, probably.:-) had a complete
set of Sams Photofact (r).  If you are really lucky, your local library
will too.

Good luck.  BTW, did you put any sort of spike protection on the power
supply?  I put 2 or 3 MOVs inside the case, and never had any problems.

Also, I assume you know about the jumper which will make the serial
port be 600/2400 baud instead of 300/1200?  I mounted a switch on the
case so I could easily switch between 300/1200/2400 (who needs 600, 
anyway? :-)
-----
    Rusty Carruth      N7IKQ   DOMAIN: rusty@cadnetix.com
    Cadnetix Corp.             UUCP:   cadnetix!rusty
    5775 Flatiron Pkwy.                        {uunet,boulder,nbires}!cadnetix!rusty
    Boulder, CO 80301          (303) 444-8075