Date   : Mon, 18 Jul 1988 21:21:16 GMT
From   : dartvax!eleazar.dartmouth.edu!joeh@bu-cs.bu.edu (Joseph L. Hill)
Subject: pipmodem.asm

I grabbed pipmodem.asm from simtel20 and typed it in by hand
on my micro decision running cpm 2.2, it compiles exactly
as the specified in the pipmodem.doc instructions but when
i run it and hit return the program exits and i go back
to the A> prompt. I've checked the source code against
the listing i produced until my eyes turned red, any ideas?
im having an awful time trying to get this thing to see
my modem, anyone familiar with how the jumpers should be set?
im "winging it", also, i made a male to male cable so i could
plug it into my modem, using only pin 2,3 and 8, trans, receve, 
ground, any one know if that is correct for this machine? 

-forever confused and destined to never get any software -joe



     Joseph L Hill     joeh@dartvax.UUCP                                  

     USNET:   {linus|decvax|cornell|astrovax}!dartvax!joeh  
      ARPA:   joeh%dartmouth@csnet-relay                    


End of INFO-CPM Digest
******************************