Date   : Fri, 23 Nov 1990 17:43:36 GMT
From   : swrinde!cs.utexas.edu!hellgate.utah.edu!fcom.cc.utah.edu!cc.utah.edu!cc.usu.edu!slsw2@ucsd.edu
Subject: BigBoard II

In article <1990Nov22.030505.6665@simasd.uucp>, donm@pnet07.cts.com (Don
Maslin) writes:
> The WD1771 FDC controller used in the Big Board is the same as used in
> the Xerox 820 and is capable of using 5.25" floppies.  What needs to be
> done is to cut the data transfer rate from the 8" rate (500,000K bps) to
> the 5.25" rate (250,000K bps) and, obviously, accommodate the 34 pin
> connector on the 5.25" drive.

Or, you can just grab some 1.2 MB drives from an IBoringM AT. They run at
500 KHz, so should work just fine. 
-- 
==============================================================================
Roger Ivie

35 S 300 W
Logan, Ut.  84321
(801) 752-8633
==============================================================================