Date   : Wed, 29 May 1991 02:44:49 GMT
From   : cis.ohio-state.edu!zaphod.mps.ohio-state.edu!menudo.uh.edu!nuchat!farwest!Uucp@ucbvax.Berkeley.EDU (JOHN ANDEERSON)
Subject: Kaypro drive ID was Re: (none)

Dean, As previously mentioned the DS jumpers are the key.  I would 
recommend rotating the drives, A to B B to A.  REmove the terminating 
resistor form drive B, the last drive in the chain.  place the 
Terminating resistor in Drive A.  THe T-RES will look like an intgrated 
circuite but will have a 10 ohm symbol on it.  Set drive A for DS0 on the 
jumpers, set drive B to DS1 on the jumpers.  If you jumpers begin at 1 - 
4 instead of 0 - 3, use 1 and 2 respectively.  If you have any questins 
please feel feel free to call MIDECON ZNODDE #16 (518) 489-1307 STARLINK 
9192.  GOOD LUCK,  John-A ZNode #16
 * Origin: The Black Box RCP/M MSBBS, 713-480-2686 HST/V32/V42bis (106/601)