<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>
Date   : Fri, 14 Jun 1991 05:05:26 GMT
From   : baron!baron!pnet07!donm@nosc.mil (Don Maslin)
Subject: Re: Need some help with PINOUTS

tericks@plains.NoDak.edu (Terry Erickson) writes:
>     I have a question about a NEC APC.
>
>     I am trying to hook up a modem to that computer, BUT its port on the
>back is no normal Serial Port, it looks more like the Centronics Parallel
>Printer port (Cent 36 I think) instead of a DB25.  And I seemed to have
>misplaced my manuals for the pinouts on that type of Serial Port, could
>anyone give me some assistance??

>    That way, with a little help from a Jumper Box and a normal Parallel
>Printer cable, I could have Modem Communications.

Following is a tabulation of:
                             Table 3-20
               Serial I/O Connectors Pin Assignments


                    Pin #   Pin #   Pin #
           Signal    at A    at B    at C       Remarks
      -----------------------------------------------------------------
      Frame Ground    1       1       1
          SD          2       2       3       Send Data
          RD          3       3       5       Receive Data
          RS          4       4       7       Request to Send
          CS          5       5       9       Clear to Send
          DR          5       5       11      Data Set Ready
      Signal Ground   7       7       13
          CD          8       8       15
      ---------------------------------------------------
                      9       9       17      No Signal
                      10      10      19
                      11      11      21
                      12      12      23
                      13      13      25
                      14      19      2
      ---------------------------------------------------
         ST2          15      20      4       Transmit Clock (TxC)
      ---------------------------------------------------
                      16      21      6
      ---------------------------------------------------
         RT           17      22      8       Receive Clock
      ---------------------------------------------------
                      18      23      10
                      19      24      12      No Signal
      ---------------------------------------------------
         ER           20      25      14      Data Terminal Ready
      ---------------------------------------------------
                      21      26      16
                      22      27      18      No Signal
                      23      28      20
      ---------------------------------------------------
         ST1          24      29      22      Transmit Clock (RxC)
      ---------------------------------------------------
                      25      30      24      No Signal
      ---------------------------------------------------

NOTE: 'A' is at the modem connector
      'B' is at the back panel connector
      'C' is at the processor board header

I infer that the serial connector is the right hand one, but I'm not
sure.

Hope this helps.
                                               - don



Keeper of the CP/M System Disk | UUCP: {nosc ucsd crash ncr-sd}!pnet07!donm
Archives for the Dino(saur)SIG | ARPA: simasd!pnet07!donm@nosc.mil
- San Diego Computer Society - | INET: donm@pnet07.cts.com


End of INFO-CPM Digest V91 Issue #112
*************************************
<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>