<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>
Date   : Thu, 20 Jun 1991 18:10:32 GMT
From   : zephyr.ens.tek.com!wrgate!amadeus!donk@uunet.uu.net (Donald C. Kirkpatrick)
Subject: Re: Reply to question about fast terminal for Kaypro 2

In article <9151911@ub.cc.umich.edu> Steve_Graham@UB.CC.UMICH.EDU writes:
>There is a fast terminal program available from simtel called FASTTERM
>that might work at 19200.  It has NO features, as far as I know.  On MY   
>Kaypro II I can't get above 1200 baud without interrupts.  FASTTERM works
>at 2400 (nothing else does) which is as high speed as I have been able to try.

I have used MEX at 9600 baud quite successfully on my kaypro II. It
works just fine; it never retransmits a block so I knowcharacters are
not being missed. The machine on the other end is also a CP/M machine
running MEX. I may have a small advantage though; I have installed the
modification to run the Kaypro at 5 MHz. rather than the stock 2.5
MHz. I may also have an advantage in having a hard disk on the Kaypro,
but with the hand-shaking I don't think that should have any effect.
Both MEX and the Kaypro overlay are on Simtel-20.


--
       -Don Kirkpatrick (donk@amadeus.WR.TEK.COM)
               UUCP:   ...!uunet!tektronix!amadeus.wr.tek.com!donk
               ARPA:   <donk%amadeus.wr.tek.com@RELAY.CS.NET>

<< Previous Message Main Index Next Message >>
<< Previous Message in Thread This Month Next Message in Thread >>