Date   : Wed, 23 Sep 1992 02:48:01 GMT
From   : digex.com!gjw@uunet.uu.net (Gregory Watson)
Subject: Re: Half dead Kaypro II

In article <22SEP199211510304@donald.uoregon.edu> rbear@donald.uoregon.edu
(Richard Bear) writes:
>Switch on, warms up,
>CRT says put disk in drive. There is only the master disk, which I ASSUME is
>not damaged, but the drive doesn't pay it any mind, or perhaps the board
>doesn't pay the drive any mind. I opened up the case, admired the clean lines
>of the interior, and swapped the drives, on the theory that A is broke and 
>maybe B ain't. No response. Next move? 

       Did you also remember to swap the terminating resistor?  Also
have you tried cleaning the drives?  Also try it with just one drive
connected.

                       Gregory Watson
                       gjw@access.digex.com
                       gjw1@midway.uchicago.edu (if the above fails)