Date   : Fri, 07 Apr 2006 21:33:17 +0200
From   : Anders Carlsson <anders.carlsson@...>
Subject: Re: Using an AKF30 with a Beeb

On Fri, 7 Apr 2006, Mike wrote:

> Looks like you might need some kind of resistive attenuation
> as in a SCART, since it's analogue RGB

A bit related, I gave up on using the TTL mode on my 1084 monitor.
Instead I went for analog RGB mode and installed the resistors.
Just like SCART, this monitor appears to use 0.7 - 1 Vpp inputs
with 75 ohm impedance. It is said 330 ohm or higher is enough to
reduce the voltages from TTL level. In the end, I managed to
scavenge some 470 ohm resistors which I installed to success.

No idea what voltages the mentioned monitor expects, but if it has
specs like the other two, similar resistor values should work?

-- 
Anders Carlsson