Date   : Sat, 31 Oct 2009 17:55:14 +0000
From   : acorn@... (Andy Ford)
Subject: L3 FS

I seem to remember having that error with using L3 via floppy discs, it 
was rare, although its quite possible I have mixed it up with the 
verification error that old floppy discs can give on L3.

I'm probably way out here, but when you initialised partition 0, what 
did you put in for "next drive?" , and the same question for partition 1 
too.

Logic would say partition 0: next drive = 1 and partition 1: next drive:4

If you want to re-initialise partition 1, try putting 4 in when asked 
about the next drive.

I wonder (although slightly off topic) , how easy that information is to 
change on an existing partition too, as I'd like to at some point 
(typically I will use just one partition and choose 4 for next drive)

Although not terribly helpful (sorry) , I'm hoping it may give you a 
couple of ideas / thoughts. :)


Andy.



Mark Usher wrote:
> Have just been trying to mount a second hard drive in BeebEm on Level3
> fileserver.
>
> I "WSFInit"ed Drive 1 which was fine, and gave the disk a different name to
> the "partition" in drive 0.
>
> When I try to start the Fileserver, I get F.S. Error 5A. which according to
> the Econet Error Codes, is Level II and Filestore only. Disc of same name
> already in use!
>
> I know some of you guys have had multiple drives running on Level3 recently.
> Any hints?
>
> -Mark
>
>
> _______________________________________________
> bbc-micro mailing list
> bbc-micro@...
> http://lists.cloud9.co.uk/mailman/listinfo/bbc-micro
>
>