Date   : Fri, 27 Aug 2010 19:30:34 +0100
From   : afra@... (Phill Harvey-Smith)
Subject: Does MOS 4.0 work properly in a full Master ?

Steve Inglis wrote:
> Hey
> 
> Have you considered the CMOS ram, the hardware and code may have been 
> changed to deal with the EEPROM replacement.  I'm not sure that BeebEM 
> would show any problems since its not real hardware.

That is indeed true for the Master Compact MOS (5.0, 5.1), but I think 
the OP was talking about the Master ET MOS (4.0), which will work on a 
standard master board and vice versa.

Though there is a link that needs to be changed, dependent on what size 
ROM you are using. Though annoyingly it's a 3 pin line, and the outer 
two pins need to be linked in one of the configs.

Cheers.

Phill.

-- 
Phill Harvey-Smith, Programmer, Hardware hacker, and general eccentric !

"You can twist perceptions, but reality won't budge" -- Rush.